Free Delivery

    On Orders Over £50

    Safe & Secure Shopping

    Powered by Braintree, a PayPal company

    Seen it cheaper elsewhere?

    Call us on 0115 964 9181

Aico Hard Wired Alarm Control Switch

Manufacturer : Aico
Delivery Time:

1 to 2 Working Days

A mains powered, multiple alarms, hard wired control switch.

The Aico Ei1529RC Hard Wired Control Switch is used to control all the alarms in a system from one place. Aico highly recommend fitting an Ei1529RC control switch if you have smoke, heat and carbon monoxide alarms on the same system as it’s essential that you can tell which alarm has sounded. From this you can identify which danger is present and the action you should take.

This mains powered accessory increases the flexibility and user friendliness of the alarms by allowing the user to remotely Test, Locate and Silence alarms in the system: Test – The alarm system: Locate – The alarm that has been activated: Silence– Any nuisance alarms

  • Complies with electrical safety requirements: EN61000-6-1:2007 Et EN61000-6-2:2005 (EMC Directive) and EN60065:2001 + A12:2011 (Low voltage directive).
  • Carries the CE mark to indicate conformance to Low Voltage and Electromagnetic Compatibility Directives.
  • Wall mounted for ease of use – can be fixed with surface mount box supplied, or will fit a standard recessed box (not supplied).
  • Suitable for siting at any convenient point in the property. Up to 4 x Ei1529RC switches can be installed in a system along with a maximum of 20 x 2110e, 160e or 140RC Series smoke and heat alarms or 260ENRC Series CO alarms.
  • The unit incorporates 3 switches marked ‘Locate’, ‘Test’ and ‘Hush’. These provide control features as detailed below and a mains check function as detailed below.
  • Locate’ – In an alarm state, pressing and releasing the ‘Locate’ switch will silence all alarms in the system except for the alarm that initiated the alarm state.
  • Test’ – Pressing the ‘Test’ switch into the ‘on’ position will test all the alarms in the system. This operation is equivalent to pressing the ‘Test’ button on all alarms in the system simultaneously.
  • Hush’ – Momentarily pressing the ‘Hush’ button switch allows remote silencing of false alarms. The system will reset automatically after approximately 10 minutes.

  • Copyright © 2019 ERF Electrical Wholesalers Ltd. All rights reserved.