PowerPack Instantaneous Water Heater 7.0 kW
3 to 5 Working Days
The Santon PowerPack gives domestic hot water for student accommodation, bedsits and remote areas such as cloakrooms and garages. The unit can supply a spray tap and/or shower outlet, as long as only one outlet is used at a time. This unit is available in 7 kW and 9 kW ratings. Overheating is prevented due to the pre-set safety cut out set to 88 Degrees Centigrade. The minimum water pressure needed is 1 bar and the maximum is 7 bar. The unit can be drained via the drain plug to prevent freezing, which can occur if the unit is left unused.
A pressure relief valve set to open at 10 bar is included together with a tee-piece which must be fitted on the heater inlet pipework. This valve MUST be connected to waste (drain) via a tundish. The drain pipe should fall continuously and be of 22mm width discharging in a safe and visible manner. The pipe must not be reduced in width or blocked under any circumstances and it should be protected from frost.
- Kiwa approved. CE marked. IP X5 rated.
- Two-year warranty, full detail included in the installation instructions supplied with each unit.
- Long-life white moulded ABS outer case.